Trick with paracetamol to remove burnt from the iron

Without a doubt, how many times has it happened to us that the iron burns to the point that it is impossible to use it again. Which is why it needs to be cleaned urgently.

Needless to say, household appliances require certain maintenance for them to work correctly, so when the iron burns it is necessary to look for solutions.

Fortunately, there are homemade methods or tricks that allow us to fix appliances so we can use them immediately. In fact, we can use a commonly used medication that we have at home such as  Paracetamol.

Although it may seem incredible, this pill is miraculous. Next let’s see the solution we can give to a burnt iron:

Trick with paracetamol to remove burnt from the iron

It is a simple but highly effective trick, now we will see how to do it:

Ingredients

• burnt iron
• 1 Paracetamol tablet
• 1 Tweezers

Procedure, step by step:

1. To start, heat the rusty or burnt iron to maximum temperature.
2. When we see that it is very hot, take the paracetamol with tweezers and rub it on the burned or rusty area.
3. Next step, once we have covered it well with the tablet and have scrubbed it, it is time to wipe it with a cloth to remove all debris.
4. Let’s remember, we can repeat the cleaning process as many times as necessary.

Now we have a very clean and stain-free iron ready to use!

Tips:

If we notice that the spots are too marked, let’s intensify the process with paracetamol. Its components help a lot in cleaning although it may seem difficult to believe, let’s try it and see the excellent results.

We can also use other homemade tricks with ingredients that we already have at home, just moisten a cloth in the water and vinegar mixture :

1. We begin by moistening a clean cloth in a little warm white vinegar and passing it over the iron.
2. We can also add a couple of tablespoons of salt to the vinegar and rub until the marks are eliminated.
3. In fact, if necessary, we repeat the process as many times as the stains require until they are removed.

Another method is with baking soda :

1. First, mix 2 tablespoons of baking soda with the same proportion of water.
2. Then, with the cold iron we apply the mixture and after a few minutes, we remove the baking soda with a damp cloth.
3. Finally, we will observe the impeccable results of an iron free of black traces of burns.

Let’s try these tricks and enjoy a flawless iron!